Brochures 
READING ERROR CODES AUTOMATIC TRANSMISSION (ATX)
READING ERROR CODES |
Reading error codes automatic transmission (ATS) is similar to reading the engine error codes (See section "Check ENGINE error codes"), with the following differences: - Bridge pins TAT and GND (See section "Diagnostic connector")- The codes are read by hold light Below are the codes and the reasons behind them. |
| ATX ERROR CODES |
| CODE | CIRCUIT |
| 01 | NE1 (crankshaft position sensor) |
| 06 | Vehicle speed sensor |
| 12 | Throttle position sensor |
| 14 | BARO sensor (located within PCME) |
| 55 | Vehicle speed pulse generator |
| 56 | ATF thermosensor |
| 57 | Reduce torque signal 1 |
| 58 | Reduce torque signal 2 |
| 59 | Torque reduced/ECT sensor |
| 60 | 1-2 shift solenoid valve |
| 61 | 2-3 shift solenoid valve |
| 62 | 3-4 shift solenoid valve |
| 63 | converter lock-up solenoid valve |
| 64 | 3-2 timing solenoid valve |
| 65 | converter lock-up valve |
| 66 | line pressure solenoid valve |
This information and more at: http://homepage.ntlworld.com/mx6-uk/maint/maint.htm